Wide drone view of a metal commercial building mid-coating, with a gravel lot, stored equipment, and farm fields around it

About Our York Metal Roof Coating Work

Inspection First, Repairs Next, Coating Last

Here is what to expect about our York metal roof coating work, from the first roof walk to the final thickness check.

  • Roof Walked Before Pricing
  • Repairs Listed In Writing
  • Film Thickness Measured
Gloved hands preparing a rusted seam on a ribbed metal roof panel before coating

What to Know About Our York Metal Roof Coating Work

Questions about our York metal roof coating work usually start with price, and the honest answer starts on the roof. We walk every slope, open a few laps, and check screws before we say whether coating fits. If the panels are too thin, we say so and point you toward replacement.

  • Rusted laps and loose screws are fixed before coating
  • Coating thickness follows the product sheet
  • Problem areas are photographed for your records
  • You walk the finished roof with us

Panels Rusting Faster Than You Expected?

Rust that spreads in a season usually points to trapped water at laps or gutters. Get a planning range now and an inspection to find the cause.

Get A Free Estimate(610) 984-0541

What We Check Before Coating a York Roof

These checks happen on every roof before a coating system is chosen.

  • Panel thickness and any holes along the ribs
  • Side laps and end laps, opened where rust shows
  • Screw rows for backed-out heads and worn washers
  • Curbs, vents, and exhaust stacks for cracked sealant
  • Gutters, eaves, and downspouts for blockage and rust
  • Interior stains and wet insulation under leak spots
  • Safe access routes and load limits for foot traffic
  • Existing finish adhesion with a tape or pull test

What We Will and Will Not Do on a York Roof

Coating covers a roof surface, so we are careful about what goes under it.

What We Do

  • Replace screws that spin or back out
  • Treat rust inside laps before closing them
  • Measure coating thickness as it goes on
  • Tell you plainly when replacement fits better
  • Give you photos of repairs before coating

What We Will Not Do

  • Coat over panels with rust holes
  • Seal wet insulation under a new surface
  • Skip primer on bare or rusted steel
  • Promise a set number of years
  • Pile on extra coating instead of fixing a joint

Ask About Our York Metal Roof Coating Work

Get a free ballpark range from your roof size, or call to talk through your building.

Call Us(610) 984-0541